Rhinomat WMCM900 Automated Mat Cleaner Targets Car Wash Efficiency

The WM-CM900 automatic mat washing machine is designed to automate the cleaning and dewatering of vehicle floor mats in car detailing and professional cleaning settings. Its design combines suction rollers with pressure rollers to remove embedded dirt and extract water in a single pass. The system is positioned for high-frequency commercial use, where cleaning speed and drying time affect both customer experience and operating costs.

Technology and operating principle

The core of the WM-CM900 is a coordinated roller system. A back-suction roller is designed to pull embedded dust and dirt from the mat, while pressure rollers work in sequence to squeeze out water absorbed during cleaning. This combination of suction and compression is intended to improve cleaning results and reduce the time needed for subsequent drying.

The stated cycle time for deep cleaning a single mat is about nine seconds. That speed is central to the machine’s intended role in commercial operations that handle mats at short intervals and require consistent throughput.

Throughput and operating conditions

The machine’s stated processing capacity is 300 to 500 pieces per hour. In practice, output depends on how dirty and how large the mats are, how frequently operators load the machine, and whether the power supply remains stable. The 380V supply requirement is central to maintaining consistent operation.

Technical specifications

The WM-CM900 operates on 380V at 50/60Hz and has a rated power of 6kW. Its roller dimensions are 600mm by 30mm, and the unit weighs 78kg. The full specification set is listed below.

The machine’s external dimensions are 933mm by 648mm by 1120mm. These figures define the installation footprint and should be considered when planning service areas or cleaning bays.

Maintenance and material compatibility

Routine maintenance focuses on the rollers, whose cleaning and wear condition determine whether suction and pressing perform as intended. Operators should also remove accumulated dust and debris from the interior and check electrical connections to support safe operation at 6kW.

Because rubber, fabric, leather and other mat materials differ in abrasion resistance and water absorption, the machine is primarily intended for conventional vehicle floor mats. Material suitability should be confirmed before processing to avoid damage to special surfaces.